Suspension Of The Projector With Rigging Clamps - Barco HDX-4K20 FLEX User Manual

Physical Installation
4.5 Suspension of the projector with rigging
clamps
Rigging points and rigging clamps
When a carrying handle is mounted at the bottom side of the projector, eight slots are available to mount
rigging clamps. Four slots are longitudinally (1) oriented and four slots are transversely (2) oriented. Each slot
contains a rigging point of which the position in the slot can be adjusted depending on the size of the truss
installation. The rigging clamps can be attached to those rigging points, which allows an easy and fast
physical setup of the projector in a hanging configuration.
Image 4–8 Rigging points
Required tools
• Open end spanner 24 mm
• Open end spanner 17 mm
Required parts
4 rigging clamps
How to install and use the rigging clamps
1. Measure the distance, center tube as reference, between the two used support bars of the truss.
Image 4–9 Truss, example
2. Turn the projector upside down and slide the rigging points on there place in the slots, according the
measured distance and secure this position. To release the nuts of the rigging points use a 24 mm open
ended spanner. Ensure that the rigging points are symmetrically lined up, so that the projector will hang in
balance.
Warning:
Warning:
44 R5906070 /16 HDX 4K
2
Be careful while working with heavy loads.
Always secure the rigging points after adjustment.
1