Table of Contents
Advertisement
The following table describes the labels in this screen.
Table 236 Management > Access Control > SNMP
LABEL
General Setting
Version
Get Community
Set Community
Trap Community
Trap Destination
Version
IP
Port
Username
Apply
Cancel
48.3.5 Configuring SNMP Trap Group
From the SNMP screen, click Trap Group to view the screen as shown. Use the Trap Group
screen to specify the types of SNMP traps that should be sent to each SNMP manager.
Chapter 48 Access Control
DESCRIPTION
Use this section to specify the SNMP version and community (password) values.
Select the SNMP version for the Switch. The SNMP version on the Switch must match the
version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or
both (v3v2c).
Note: SNMP version 2c is backwards compatible with SNMP version 1.
Enter the Get Community string, which is the password for the incoming Get- and
GetNext- requests from the management station.
The Get Community string is only used by SNMP managers using SNMP version 2c or
lower.
Enter the Set Community string, which is the password for the incoming Set- requests
from the management station.
The Set Community string is only used by SNMP managers using SNMP version 2c or
lower.
Enter the Trap Community string, which is the password sent with each trap to the
SNMP manager.
The Trap Community string is only used by SNMP managers using SNMP version 2c or
lower.
Use this section to configure where to send SNMP traps from the Switch.
Specify the version of the SNMP trap messages.
Enter the IP addresses of up to four managers to send your SNMP traps to.
Enter the port number upon which the manager listens for SNMP traps.
Enter the username to be sent to the SNMP manager along with the SNMP v3 trap.
Note: This username must match an existing account on the Switch (configured in the
Management > Access Control > SNMP > User screen).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS3700/XGS3700 Series User's Guide
466
Advertisement
Table of Contents
