Fold settings
Fold settings
Introduction
When you set the fold options, there are some definitions you must know to operate the folding
device in a correct way. An overview of these settings is found below.
To edit these settings and create or edit a fold template, go to the [Preferences] - [Fold] tab and
click the [Create new] button, or the
one of the existing templates.
Settings
[Fold package]
[Full fold]
[Fan fold only]
[Reinforcement]
[Enabled]
[Disabled]
156
Chapter 3 - Define your Workflow with Océ Express WebTools
icon, that becomes visible when you move the mouse over
Description
Folded with first (Z-fold) and second
fold (cross fold).
Folded only with the first fold (Z-
fold).
Description
Glues the pre-punched strips to the
rear of the folded package.
NOTE
Only possible when [Fold-
ing method] is [With same
size back].
No glued strip.
Example
279 mm / 11 inch
or
305 mm / 12 inch
180 - 230 mm
7.1 - 9 inch
Example
193 - 198 mm
7.6 - 7.8 inch