Configure The Roll-To-Roll Mode In Océ Express Webtools - Canon Oce Colr Wave 500 Operation Manual

Configure the Roll-to-roll mode in Océ Express Webtools
Configure the Roll-to-roll mode in Océ Express Webtools
Introduction
When you want to use the take-up unit, your printer has to be in the Roll-to-roll mode. When you
enable the Roll-to-roll mode, the printer will not cut between pages. You can also configure the
Roll-to-roll mode on the user panel.
NOTE
If Roll-to-Roll mode is enabled, each print job is delivered to the [Back output], even if you set
the [Top delivery tray] as output location for your prints.
NOTE
To calibrate the printer the Roll-to-roll mode must be disabled.
Procedure
1.
Open the [Preferences] - [System defaults] tab.
2.
Click on [Edit] in the [Job management] section, or click on the [Roll-to-roll mode] setting.
3. Select [Enabled] or [Disabled].
4. Click [Ok] to confirm, or [Cancel] to reject your entries.
146 Chapter 3 - Define your Workflow with Océ Express WebTools