Configure the Finishing settings
Define the finisher type
Introduction
You must set the type of finishing option.
Procedure
1.
Navigate to [Configuration] - [Printer setup] - [Finishing].
2.
Set the value of [Finisher type] to the type of finishing that is connected to the external output at
the back of the printer.
The default value is [No finisher]. You must only change this value if your hardware configuration
changes.
3.
Click [Ok] to confirm your entries or [Cancel] to reject your entries.
Chapter 3 - Define your Workflow with Océ Express WebTools
Configure the Finishing settings
153