Fold Settings - Canon Océ PlotWave 450 Operation Manual

Fold settings

Fold settings
Introduction
You can set the fold options in the fold template under the [Preferences] - [Fold] tab. For more
information on how to create a template see,
When you set the fold options, make sure you set them accordingly to operate the folding device
in a correct way. Use the settings overview explanation below.
Folding
[Folding package]
[Full fold]
[First fold only]
[Package type]
[Standard]
[Alternative]
[Folding method]
[With same size back] (DIN-
B).
104 Chapter 3 - Define your Workflow with Océ Express WebTools
Create a new template on page
Description
Folded with first (Z-fold) and second
fold (cross fold).
Folded only with the first fold (Z-
fold).
Description
The default value. This setting is suit-
able for most situations, in order to
fold a DIN drawing (A) to a DIN pack-
age with the legend on top (B).
This setting is suitable for a non-
standard situation, in order to fold a
drawing with the legend located on
the left of the leading edge, seen
from the printer (A), to a package
with the legend on top (B).
Description
Folded package, but the last fold
(rear) is over the full width.
The previous fold could be shorter.
98.
Example
Example
A
A
Example
B
B
4