Table of Contents
Advertisement
6.8.11. Modify Password
To set or change the SAS RAID controller password, select "System Controls" from the menu and click on
the "Modify Password" link. The "Modify System Password" screen appears.
The manufacture default password is set to 0000.
The password option allows user to set or clear the SAS RAID controller's password protection feature.
Once the password has been set, the user can only monitor and configure the SAS RAID controller by
providing the correct password. The password is used to protect the SAS RAID controller from
unauthorized entry. The controller will check the password only when entering the main menu from the
initial screen. The SAS RAID controller will automatically go back to the initial screen when it does not
receive any command in 5 minutes. Do not use spaces when you enter the password, If spaces are used,
it will lock out the user. To disable the password, leave the fields blank. Once the user confirms the
operation and clicks on the "Submit" button, the existing password will be cleared. Then, no password
checking will occur when entering the main menu from the starting screen.
6.8.12. Update Firmware
Please refer to the appendix A "Upgrading Flash ROM Update Process".
6.9. Information
6.9.1. Raid Set Hierarchy
Use this feature to view the SAS RAID controller current RAID set, current volume set and physical disk
information. The volume state and capacity are also shown in this screen.
96
Advertisement
Table of Contents
