Table of Contents
Advertisement
Note: Event Notification Table refers to Appendix E. After you confirm and submit configurations, you
can use "Generate Test Event" feature to make sure there settings are correct.
D-3-2 Using Onboard NIC Installation
By using the built-in LAN port on the RAID controller- RAID controller using built-in LAN interface. You
can use the browser-based manager or CLI SNMP configuration to setup the firmware-based SNMP
configuration. The following screen is the firmware-embedded SNMP configuration setup screen using
browser-based manager:
To launch the above browser-based RAID controller SNMP function, click on the "System Controls" link.
The "System Controls" menu will show available items. Select the "SNMP Configuration" item. The
firmware-embedded SNMP agent manager monitors all system events and the SNMP function becomes
functional with no agent software required. The following article describes a best practice methodology
for setting this up in the "SNMP Traps Configurations".
1. SNMP Trap Configurations
Enter the SNMP Trap IP Address.
2. SNMP System Configurations
Community name acts as a password to screen accesses to the SNMP agent of a particular network
device. Type in the community names of the SNMP agent. Before access is granted to a request
station, this station must incorporate a valid community name into its request; otherwise, the SNMP
agent will deny access to the system. Most network devices use "public" as default of their
community names. This value is case sensitive. The system Contact, Name and Location will be
shown in the outgoing SNMP trap.
3. SNMP Trap Notification Configurations
Please refer to Appendix E of Event Notification Configurations.
D-3-3 Using In-band PCI + SNMP Extension Agent Installation
By using the IP address assigned to the operating- RAID controller using Sans Digital SNMP extension
agent through PCIe host bus interface.
1. Set only "Community" field and select the "SNMP Port" option on the firmware-embedded SNMP
configuration function. There is no function to set other fields on "SNMP System Configuration".
The SNMP community and SNMP port can setup by using browser-based manager or CLI SNMP
configuration. To launch the above browser-based RAID controller SNMP function, click on the
109
Advertisement
Table of Contents
