Table of Contents
Advertisement
6.7.4.1.
Clone And Replace
You can enlarge your logical drives by copying and replacing all member drives with drives of
higher capacity. The existing data in the logical drives is copied onto the new drives, and then
the original members are marked as "Offlined".
6.7.4.2.
Clone Only
The stand-by disk will clone the logical drives without substituting it. The status of the stand-by
drive will be marked as "Offline" after the cloning process. The source drive will remain a
member of the logical drive.
6.7.5. Abort Cloning
Use this function to stop the ongoing clone disk action.
6.7.6. Set Disk To Be Failed
It sets a normal working disk as "failed" so that users can test some of the features and functions.
6.7.7. Activate Failed Disk
It forces the current "failed" disk in the system to be back online. "Activate Failed Disk" function has no
effect on the removed disks, because a "removed" disk does not give the controller a chance to mark it
as "failure".
Followings are considered as "Removed-Disk":
Manually removed by user.
•
Losing PHY connection due to bad connector, cable or backplane.
•
Losing PHY connection due to disk fail.
•
Basically, in the eyes of the controller, the disk suddenly disappears due to any reason.
84
Advertisement
Table of Contents
