Table of Contents
Advertisement
General Configuration: Binding IP: Restrict ArcHTTP proxy server to bind only single interface (If more than
•
one physical network in the server).
HTTP Port#: Value 1~65535
•
Display HTTP Connection Information To Console: Select "Yes" to show Http send bytes and receive bytes
•
information in the console.
Scanning PCI Device: Select "Yes" for RAID controller
•
Scanning RS-232 Device: No Scanning
•
Inband Device: No
•
Mail (alert by Mail) Configuration: Many users require that email notifications be sent to the appropriate
•
administrators when an alert is detected. To set up your mail servers, click on the "Mail Configuration" link.
The "SMTP Server Configurations" allows you to define settings for your mail server. This setup screen is
shown as below:
The following article describes a best practice methodology for setting this up in the "SMTP Server Configurations".
1. SMTP Server Configuration: SMTP Server IP Address: Enter IP address of the SMTP server to configure your
mail program correctly. Ex: 192.168.0.2.
2. Mail Address Configurations: Sender Name: This is the sender name that the e-mail alerts will appear to be
coming from. Ex: RaidController_1.
3. Mail address: This is the mail address that the e-mail alerts will appear to be coming from, but don't type IP
to replace domain name. Ex: RaidController_1@sansdigtial.com.
4. Account: Enter the valid account if your SMTP mail server requires authentication.
the valid password if your SMTP mail server requires authentication.
5. Event Notification Configurations: This step involves setting up of notification rules. Notification
rules instruct ArcHTTP on the notifications that should be sent when certain types of alerts are detected.
6. MailTo Name: Enter the alert receiver name that will be shown in the outgoing mail.
65
Password: Enter
Advertisement
Table of Contents
