Table of Contents
Advertisement
2. You must have administrative level permissions to install SAS RAID controller ArcHTTP proxy server
software. This procedure assumes that the SAS RAID hardware and driver are installed and operational in
your system.The following details are the installation procedure of the SAS RAID controller for Linux
ArcHTTP proxy server software.
a. Run the ArcHTTP proxy server by using the following command.
Usage: ./archttp32 (TCP_PORT) or ./archttp64 (TCP_PORT).
Parameters: TCP_PORT value= 1~65535 (If TCP_PORT assigned, ArcHTTP will start from this port.
Otherwise, it will use the setting in the archttpsrv.conf or default 81). This is the port address
assigning for the ArcHTTP configuration
(Cfg Assistant). Such as: archttp64 1553
b. ArcHTTP server console started, Controller card detected then ArcHTTP proxy server screen
appears.
Controller(s) list
-------------------------------------------
Cfg Assistant : Listen to port[1553].
Controller[1](PCI) : Listen to port[1554].
Binding IP:[0.0.0.0]
Note: IP[0.0.0.0] stands for any ip bound to this host.
-------------------------------------------
##############################
Press CTRL-C to exit program!!
##############################
Controller [1] Http: New client [9] accepted
Controller [1] Http: New Recv 243 bytes
Controller [1] Http: Send [174] bytes back to the client
c. If you need the "Cfg Assistant", please refer to section 5.6 ArcHTTP Configuration.
d. For detailing about McRAID storage manager to customize your RAID volume set is discussed in
Chapter 6.
63
It depends on your OS version.
Advertisement
Table of Contents
