Table of Contents
Advertisement
When starting a system with a SAS RAID controller installed, it will display the following message on the monitor
during the start-up sequence (after the system BIOS startup screen but before the operating system boots):
The McBIOS RAID manager message remains on your screen for about nine seconds, giving you time to start the
configuration menu by pressing Tab or F6. If you do not wish to enter configuration menu, press ESC to skip
configuration immediately. When activated, the McBIOS RAID manager window appears showing a selection dialog
box listing the SAS RAID controllers that are installed in the system.
The legend at the bottom of the screen shows you what keys are enabled for the windows.
Use the Up and Down arrow keys to select the controller you want to configure. While the desired controller is
highlighted, press the Enter key to enter the main menu of the McBIOS RAID manager.
Note: The default password is set to 0000; This password can be modified by selecting Change Password in the RAID
System Function section.
17
Advertisement
Table of Contents
