Table of Contents
Advertisement
Restore
Normal
Note: The FBM status will be shown on the web browser of "Hardware Monitor Information" screen.
B-5 Installation
1. Follow these steps to attach the flash-based backup module to the RAID controller.
2. Turn off the system power, and unplug the power cords. Remove the mounting screw and existing bracket
from the rear panel behind the selected PCIe slot.
3. Insert the FBM in the PCIe slot and press down gently, but firmly, to ensure that the card is properly seated
in the slot.
4. Screw the bracket into the computer chassis.
5. Remove the cable that is included in the AC-SAN-1883FBM kit box. The cable has a 14-pin connector on both
ends.
6. Insert one end of the cable into the 14-pin cable connector on the 12Gb/s SAS RAID adapter and the other
end into the 14pin J4 cable connector on the FBM with super-capacitor packs, as shown in below figure.
Note:
Low profile bracket also provided for low profile installation.
•
The FBM will occupy one PCI slot on the host backplane.
•
Slow Flash 1Hz
Off (Battery)
Function
NAND Flash R/W
Calibration
Need Replace
LED1 (Green)
Flash
102
Slow Flash 1Hz
On
LED2 (Green)
Flash
Advertisement
Table of Contents
