Mercedes-Benz COMAND MY11 Operating Instructions Manual page 95

ZA COMAND NTG4.0 BR204 USA Edition A 2011; 1; 3, en-US
d2irenkl
Information about new versions of the digital
map can be obtained from an authorized
Mercedes-Benz Center. You can have the
digital map updated at the center with a DVD,
or you can update the map yourself.
i
The update process can take a long time
(over an hour), depending on the size of the
digital map. During this time, you will only
be able to switch on radio mode and to
accept incoming calls. The update will be
completed more quickly if the vehicle is
stationary.
If you carry out the update with the engine
switched off and the starter battery has
insufficient power, COMAND may
automatically switch off during the process
in order to protect the battery. If this
occurs, restart the update with the engine
running.
G
Warning
Never leave the engine running in an enclosed
space. The exhaust gases contain carbon
monoxide. Inhaling exhaust gases constitutes
a health hazard and could lead to loss of
consciousness or even death.
Updating process
Insert the DVD into the DVD changer
X
( page 128).
Y
The update begins. COMAND checks
whether the digital map on the DVD is
compatible with the navigation system and
system software.
If this is the case and the DVD's map data
has not already been installed, COMAND
starts updating the digital map.
If the map data has already been installed,
the display shows version data and a
message to this effect.
To confirm the message: press W the
X
COMAND controller.
Take the DVD out of the slot.
X
While the update is running, you will see a
message to this effect and a progress bar. The
2010-05-31T09:21:57+02:00 - Seite 93
Version: 3.0.3.6
Other settings
navigation system is not operational until the
update is complete.
i
You cannot eject the DVD during the
update. If you switch off COMAND during
the update, the update is interrupted. It
then continues from where it was
interrupted when the system is restarted.
COMAND may prompt you to change the DVD
during the update.
Press the 8 load/eject button.
X
Take the DVD out of the slot.
X
Insert the requested DVD.
X
Once the update has been successfully
completed, you will see a message to this
effect.
To confirm the message: press W the
X
COMAND controller.
Take the DVD out of the slot.
X
The update is complete.
If the update is not successfully completed,
you will see a message that the map update
is not possible.
To confirm the message: press W the
X
COMAND controller.
Take the DVD out of the slot.
X
93
Z