Mercedes-Benz COMAND MY11 Operating Instructions Manual page 90

ZA COMAND NTG4.0 BR204 USA Edition A 2011; 1; 3, en-US
d2irenkl
Other settings
88
"None" menu option
Display switched off
Currently set map orientation
:
i
During the "Move map" function you can
see additional information depending on
the position of the crosshair, such as a road
name, if the digital map supports this data.
Traffic information on the map
If you subscribe to the SIRIUS XM Satellite
Radio Traffic Message Service, traffic
information can be displayed on the map. You
can select three categories for the display.
To switch the displays on/off: press the
X
COMAND controller W to show the menu.
Select Navi in the main function bar by
X
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select Traffic Information On Map and
X
press W to confirm.
Select the category and press W to
X
confirm.
Depending on the previous state, switch
the option on O or off ª.
Incidents
R
2010-05-31T09:21:57+02:00 - Seite 88
Version: 3.0.3.6
Road sections are illustrated with a yellow
line and arrows =.
Speed & Flow
R
Road sections are illustrated with yellow or
red car icons :.
Yellow car icons: traffic jam, average speed
25 – 45 mph
Red car icons: traffic jam, average speed 5
– 20 mph
Free Flow
R
Road sections are illustrated with a green
line and arrows ;.
Speed & Flow
:
Free Flow
;
Incidents
=
Other settings
Avoiding an area
General information
COMAND makes it possible to avoid areas
you do not wish to drive through.
The calculated route may include an area to
be avoided if:
your destination is located in such an area.
R
the route uses roads that lead through an
R
area to be avoided.
i
Highways within blocked areas are always
taken into consideration in the route
calculation.