Mercedes-Benz COMAND MY11 Operating Instructions Manual page 81

ZA COMAND NTG4.0 BR204 USA Edition A 2011; 1; 3, en-US
d2irenkl
To show the menu: press W the COMAND
X
controller.
Select Navi by sliding ZV and turning
X
cVd the COMAND controller and press
W to confirm.
Select Read Traffic Messages
X
Automatically and press W to confirm.
Depending on the previous state, switch
the option on O or off ª.
Recalculating the route dynamically
If you have selected Dynamic Route, traffic
reports affecting the route are taken into
account for route calculation.
If you have selected Dynamic Route Only
After Request and COMAND recalculates
the route, a prompt will appear.
To accept the newly calculated route:
X
press W the COMAND controller.
To continue along the original route:
X
select Reject by turning cVd the
COMAND controller and press W to
confirm.
Destination memory
Home address (My address)
Entering the home address via address
entry
Enter the home address as a destination,
X
e.g. as a city, street and house number
2010-05-31T09:21:57+02:00 - Seite 79
Version: 3.0.3.6
Destination memory
( page 51). Then, save the home address
Y
without starting route guidance
( page 54).
Y
Adopting an address book entry as a
home address
To switch on navigation mode: press the
X
g function button.
To show the menu: press W the COMAND
X
controller.
Select Destination in the navigation
X
system menu bar by turning cVd the
COMAND controller and press W to
confirm.
Select From Memory and press W to
X
confirm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
Option 1: destination memory list with
character bar
Slide ZV the COMAND controller
X
repeatedly until the destination memory
list appears as a selection list.
Option 2: destination memory list as
selection list
79
Z