Mercedes-Benz COMAND MY11 Operating Instructions Manual page 72

ZA COMAND NTG4.0 BR204 USA Edition A 2011; 1; 3, en-US
d2irenkl
Route guidance
70
Navigation announcements
Repeating navigation announcements
G Warning
Navigation announcements are intended to
direct you while driving without diverting your
attention from the road and driving.
Please always use this feature instead of
consulting the map display for directions.
Consulting the symbols or map display for
directions may cause you to divert your
attention from driving and increase your risk
of an accident.
i
Audible navigation announcements are
muted during a telephone call.
If you have missed an announcement, you can
call up the current announcement at any
time.
To show the menu: press W the COMAND
X
controller.
Select + in the navigation system menu
X
bar by turning cVd the COMAND
controller and press W to confirm.
Switching navigation announcements
on/off
To switch off: press the B button during
X
an announcement.
You will briefly see the message: The
guidance instructions have been
muted.
To switch on: press W the COMAND
X
controller.
Select + in the navigation system menu
X
bar by turning cVd the COMAND
controller and press W to confirm.
i
COMAND automatically switches the
navigation announcements back on if:
you have a new route calculated.
R
you switch COMAND back on again or
R
start the engine.
2010-05-31T09:21:57+02:00 - Seite 70
Version: 3.0.3.6
Reducing volume during a navigation
announcement
The volume of an active radio of video source
can be automatically reduced during a
navigation announcement.
Select Navi in the main function bar by
X
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select Audio Fadeout and press W to
X
confirm.
The function is switched on O or off ª,
depending on the previous status.
Setting the volume manually
Adjust the volume using the q control
X
knob during a navigation announcement.
or
Select + in the map view with the menu
X
shown and adjust the volume using the
q control knob.
Blocking a route section affected by a
traffic jam
This function blocks a section of the route
ahead of you. The length of the section of
route to be blocked can be adjusted. If
possible, COMAND calculates a detour
around the blocked section of the route.
To switch on navigation mode: press the
X
g function button.
To show the menu: press W the COMAND
X
controller.
Select Route in the navigation system
X
menu bar by turning cVd the COMAND
controller and press W to confirm.
Select Detour and press W to confirm.
X
To block a section of the route: select
X
Longer or Shorter repeatedly and confirm
using W until the desired section has been
selected.