Mercedes-Benz COMAND MY11 Operating Instructions Manual page 164

ZA COMAND NTG4.0 BR204 USA Edition A 2011; 1; 3, en-US
d2irenkl
General information
162
Remote control
Overview
To switch the screen on/off
:
To switch the button lighting on/off
;
To select the screen for remote operation
=
To select a menu or menu item with arrow
?
keys
To confirm the selection or setting with
A
9
To switch sound on/off (on wired
B
headphones)
To adjust the volume (for wired
C
headphones)
To skip a track, fast forward/rewind
D
To select a track, direct entry
E
To exit a menu (back)
F
2010-05-31T09:21:57+02:00 - Seite 162
Version: 3.0.3.6
Selecting a screen for remote operation
The remote control allows you to operate one
of the two rear-compartment screens. To do
so, you will need to switch the remote control
to the corresponding screen.
To select the left-hand screen: turn
X
thumbwheel = until "L REAR" is
highlighted in the window.
To select the right-hand screen: turn
X
thumbwheel = until "REAR R" is
highlighted in the window.
Switching the screen on/off
If the key is in position 0 or 1 in the ignition
lock (see vehicle Operator's Manual), or the
key is not inserted, the screens in the rear will
switch off after 30 minutes. Before the
screens switch off, they show a message to
this effect.
You can switch the screens back on.
However, this will discharge the starter
battery.
Point the remote control at the rear-
X
compartment screen which has been
selected for remote operation.
Press on/off button : on the remote
X
control.
The respective rear-compartment screen
switches on or off.
i
The screen can only be switched on using
the remote control when the ignition is
switched on.
Switching the button lighting on/off
Press button ; on the remote control.
X
Depending on the previous state, the
button lighting is switched on or off.
i
If you do not use the remote control for
15 seconds, the button lighting switches
off automatically.