Mercedes-Benz COMAND MY11 Operating Instructions Manual page 68

ZA COMAND NTG4.0 BR204 USA Edition A 2011; 1; 3, en-US
d2irenkl
Route guidance
66
on the map varies according to the icon.
You can select the icons that COMAND will
display ( page 86).
Y
If there are points of interest, you will see
a message to this effect.
i
You also see this message if you have
selected the menu item No Symbols under
"Map display" (
Y
To confirm the message: press W the
X
COMAND controller.
Point of interest on the map
Information about the highlighted point of
:
interest
Highlighted point of interest
;
To select a point of interest: select
X
Next or Previous and press W to confirm.
To show details for the selection: select
X
Details and press W to confirm.
To start route calculation: select Start
X
and press W to confirm.
A prompt appears asking whether the point
of interest should be used as the
destination.
Select Yes or No and press W to confirm.
X
If you select Yes, route guidance starts.
If you select No, you can choose a new point
of interest.
page 86).
2010-05-31T09:21:57+02:00 - Seite 66
Version: 3.0.3.6
Route guidance
General notes
G
Warning
COMAND calculates the route to the
destination without taking into account the
following, for example:
Traffic lights
R
Stop and right-of-way signs
R
Lane merging
R
Parking or stopping prohibited areas
R
Other road and traffic rules and regulations
R
Narrow bridges
R
COMAND may give incorrect navigation
commands if the data in the digital map does
not correspond with the actual road/ traffic
situation. For example, if the traffic routing
has been changed or the direction of a one-
way road has been reversed.
For this reason, you must always observe
applicable road and traffic rules and
regulations during your journey. Road and
traffic rules and regulations always have
priority over the navigation commands
generated by the system.
Route guidance begins once a route has been
calculated ( page 54).
Y
COMAND guides you to your destination by
means of navigation commands in the form
of audible navigation announcements and
route guidance displays.
The route guidance displays can only be seen
if the display is switched to navigation mode.
If you do not follow the navigation
announcements or if you leave the calculated
route, COMAND automatically calculates a
new route to the destination.
If the digital map contains the corresponding
information, the following applies:
when selecting a route, COMAND tries to
R
avoid roads that only have limited access,