Mercedes-Benz COMAND MY11 Operating Instructions Manual page 89

ZA COMAND NTG4.0 BR204 USA Edition A 2011; 1; 3, en-US
d2irenkl
Select Arrival Time / Distance,
X
Current Street, Geo-coordinates or
None and press W to confirm.
To exit the menu: slide XVY the COMAND
X
controller.
Arrival time/distance to the destination
Arrival time/distance display switched on
Icon for destination
:
Distance to the destination
;
Icon for estimated time of arrival
=
Estimated time of arrival
?
You can only see this display during route
guidance. While scrolling the map
( page 59), you will see data, e.g. road
Y
names, depending on the crosshair position,
if the digital map supports this data.
i
During route calculation, or if the vehicle
is traveling on a non-digitized road, the
linear distance to the destination is shown.
In this case, the display will be grayed out.
2010-05-31T09:21:57+02:00 - Seite 87
Version: 3.0.3.6
Map usage and settings
Road display
Road display active
Road names or numbers, e.g. for
:
highways
Geo-coordinate display
Geo-coordinate display active
Current height above average sea level,
:
rounded
Current vehicle position: latitude
;
coordinates
Current vehicle position: longitude
=
coordinates
Number of GPS satellites currently being
?
used
There must be sufficient GPS reception for all
displays to be shown. If this is not the case,
the display will be grayed out. Height
display : may vary from the actual value
because the navigation system uses the GPS
signal for the calculation.
While scrolling the map (
see the geo-coordinates of the crosshair
position. Height display : and number of
satellites used ? are not displayed.
87
page 59), you will
Y
Z