Adjustment Of Smudged/Faint Text - Toshiba e-STUDIO2820C Service Handbook

3.3.4

Adjustment of smudged/faint text

The smudged or faint text can be improved in the following codes.
Black mode
PS PCL XPS
7340 7341 7342
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in the codes to be adjusted and press the [START] button.
(3) Key in the adjustment value. (To correct the value once keyed in, press the [CLEAR] button.)
(4) Press the [ENTER] or [INTERRUPT] button to store the value in memory. → The equipment
goes back to the ready state.
(5) For resetting the value, repeat step (2) to (4).
(6) Let the equipment restart and perform the printing job.
(7) If the desired image has not been attained, repeat step (1) to (6).
3.3.5 Upper limit value at Toner Saving Mode
The upper limit value is adjusted at the Toner Saving Mode.
Black mode
PS PCL XPS
664-0 664-1 664-2
<Procedure>
The procedure is the same as that of
© 2008 TOSHIBA TEC CORPORATION All rights reserved
Color mode
PS PCL XPS
8130 8131 8132
Color mode
PS PCL XPS
1055-0 1055-1 1055-2
P.3-48 "3.3.2 Gamma balance adjustment (Black Mode)".
3 - 51
<Adjustment Mode (05)>
Remarks
When the small characters or fine lines in a halftone
image are faint, they can be improved by increasing
the value to raise the density level.
Acceptable values: 0 to 8 (Default: 0)
<Adjustment Mode (05)>
Remarks
The smaller the value is, the lighter the density of
image becomes.
Acceptable values: 0 to 255
e-STUDIO2820C/2830C/3520C/3530C/4520C
3
ADJUSTMENT