Toshiba e-STUDIO2820C Service Handbook page 348

[CC52] Skew adjustment motor (M1) abnormality
* The [CC52] error will be displays when the [ED10] error occurs three times in succession or
during the initial operation.
MJ-1101 (When MJ-6101 is installed)
Is there any paper remaining on the transport path?
YES
NO
Rotate the skew adjustment motor (M1). Does it rotate smoothly?
NO
YES
Are the skew home position sensor (S2) and its wiring correct?
NO
YES
Is the wiring between the hole punch control PC board (HP) and skew adjustment motor (M1)
correct?
NO
YES
1. Replace the skew adjustment motor (M1).
2. Replace the hole punch control PC board (HP).
[CC60] Punch motor abnormality
MJ-1030 (when MJ-6004 is installed)
Are the punch home position sensor (PI63) and punch motor clock sensor (PI62) working nor-
mally?
NO
YES
Is the wiring between the sensors and finisher controller PC board correct?
NO
YES
Is the punching mechanism normal?
NO
YES
1. Replace the punch motor (M61).
2. Replace the punch controller PC board.
3. Replace the finisher controller PC board.
e-STUDIO2820C/2830C/3520C/3530C/4520C
ERROR CODE AND TROUBLESHOOTING
Remove the paper.
Fix the mechanism.
Replace the sensor. Correct the wiring.
Correct the wiring.
Replace the sensors.
Correct the wiring.
Fix the mechanism.
© 2008 TOSHIBA TEC CORPORATION All rights reserved
6 - 82