Toshiba e-STUDIO2820C Service Handbook page 147

<Procedure>
[ 0 ][ 5 ]
( Code ) [ START ]
[ Power ]
[ SET ] or
[ INTERRUPT ]
Stores in memory
(*1) 1: Single-sided grid pattern in Black Mode
3: Double-sided grid pattern in Black Mode
55: Grid pattern of thick paper 2 in Full Color Mode
56: Grid pattern of thick paper 3/thick paper 4 in Full Color
57: Mode
58: Grid pattern of OHP film in Full Color Mode
59: Single-sided grid pattern of thick paper 2 in Black Mode
60: Single-sided grid pattern of thick paper 3/thick paper 4 in
98: Black Mode
Single-sided grid pattern of OHP film in Black Mode
Single-sided grid pattern in CK Mode
Note:
If the aligning amount is too large, abnormal noise (paper-folding noise) or actual paper folding
may occur during paper feeding. If the aligning amount is too small, on the other hand, a skew,
an image dislocation in feeding direction or a paper exit jam (E010) may occur. Pay attention to
the above and select the appropriate value.
© 2008 TOSHIBA TEC CORPORATION All rights reserved
( Not necessary for LCF )
( Sub-code ) [ START ]
[ Drawer
selection ]
Fig. 3-12
3 - 15
Enter new
Current value
displayed value
[ POWER ]
( *1 ) + [ FAX ]
( Test print )
e-STUDIO2820C/2830C/3520C/3530C/4520C
ADJUSTMENT
OFF/ON
3
( Exit )