Toshiba e-STUDIO2820C Service Handbook page 350

[CC80] Front jogging motor abnormality/Front aligning plate motor abnormality
MJ-1030 (Front aligning plate motor abnormality)
Is the front aligning plate home position sensor (PI36) normal?
NO
YES
Is the wiring between the finisher controller PC board and the front aligning plate motor (M33)
correct?
NO
YES
Is there any mechanical problem with the path of aligning plate?
NO
YES
1. Replace the front aligning plate motor.
2. Replace the finisher controller PC board.
[CC80] Rear alignment motor abnormality
* You receive a [CC80] error when the [ED14] error occurs three times in succession.
MJ-1101
Is there any mechanical problem when the rear alignment plate is moved?
YES
NO
Is the harness between the rear alignment motor (M10) and the finisher control PC board
(CN10) disconnected or open circuited?
l YES
NO
1. Replace the rear alignment motor (M10).
2. Replace the finisher control PC board.
[CCB0] Offset motor abnormality
MJ-1030
1. Check if the connector J104 on the finisher controller PC board is disconnected from the
offset HP sensor (SR1) or the harnesses are open circuited. Correct if any.
2. Check if the connector J107 on the finisher controller PC board is disconnected from the
offset motor (M5) or the harnesses are open circuited. Correct if any.
3. Replace the offset HP sensor.
4. Replace the offset motor.
5. Replace the finisher control PC board.
e-STUDIO2820C/2830C/3520C/3530C/4520C
ERROR CODE AND TROUBLESHOOTING
Replace the sensor.
Correct the wiring.
Fix the mechanism.
Fix the mechanism.
• Reconnect the connector securely.
• Replace the harness.
© 2008 TOSHIBA TEC CORPORATION All rights reserved
6 - 84