Toshiba e-STUDIO2820C Service Handbook page 29

Remarks:
• The [COPY] [e-FILING] [SCAN] [PRINT] [FAX] buttons on the control panel keep blinking
while data are being stored in the USB media.
• Do not disconnect the USB media while data are being stored.
• When the data of a code are printed again on the same equipment, the CSV file will be over-
written because the names of these files contain the same serial number.
• In the USB storage procedure above, lists are stored in a CSV format. The names of the CSV
files are shown below (the numbers represent the serial number of the machine:
"0123456789".)
- 201:ADJUSTMENT_LIST_0123456789.csv
- 202:SETTING_LIST_0123456789.csv
- 203:PM_LIST_0123456789.csv
- 204:PIXEL_TONER_LIST_0123456789.csv
- 205:PIXEL_SERVICE_LIST_0123456789.csv
- 206:ERROR_LOG_0123456789.csv
- 207:ERROR_LOG_0123456789.csv
- 208:FW_UPGRADE_LOG0123456789.csv
- 210:POWER_ONOFF_LOG_0123456789.csv
• PM support mode (6S):
<Operation procedure>
[6][START]
[POWER]
2: PM Support Screen
• Firmware update mode (89): Refer to "8.FIRMWARE UPDATING".
• State transition diagram of self-diagnosis modes
Normal
[0][1]
Control panel
Warming up
check mode
Ready
[POWER]
OFF
*1
To user
*1 Turn OFF the power after using the self-diagnosis mode, and leave the equipment to the user.
© 2008 TOSHIBA TEC CORPORATION All rights reserved
(Code) [START]
(Operation started)
[POWER]
ON
[0][3] [0][4] [0][5]
Adjustment
Test print
Test mode
mode
mode
State transition diagram of self-diagnosis modes
Fig. 2-1
2 - 3
[POWER] OFF/ON
(Exit)
[0][8] [9][START] [6][START]
List print PM support
Setting
mode
mode mode
e-STUDIO2820C/2830C/3520C/3530C/4520C
SELF-DIAGNOSTIC MODE
[8][9]
Firmware
update mode
2