Maintenance Part List - Toshiba e-STUDIO2820C Service Handbook

5.8

Maintenance Part List

The parts used for the maintenance of this equipment are as follows.
No. Item
1 Cleaning brush
2 Doctor blade cleaning jig
3 Wire holder jig
4 Developer material nozzle
5 Doctor-sleeve jig
6 Belt tension jig
7 Separation plate gap jig
8 Drum bag
9 Download jig (DLM board)
10 ROM
11 Download jig-2 (6 Flash ROMs)
12 ROM writer adapter (For 1881)
13 ROM writer adapter (For 1931)
*: Part list <P-I> represents the page item in "e-STUDIO2820C/2830C/3520C/3530C/4520C Ser-
vice Parts List".
© 2008 TOSHIBA TEC CORPORATION All rights reserved
Purpose
Cleaning inside of the equipment
Cleaning the doctor blade
Fixing the wire at the assembly of the carriage wire
Pouring the developer material (attached to the devel-
oper bottle)
Measuring the gap between the development sleeve
and the doctor blade
Adjusting the belt tension at the installation of the
scan motor
Measuring the gap between the separation plate and
the fuser belt
Storing the drum
Updating the scanner/options ROM
Installing the DLM board
Updating the system/engine/scanner ROM
Writing the data of PWA-DWNLD-350-JIG2
Writing the data of PWA-DWNLD-350-JIG2
5 - 33
Parts list
<P-I>*
101-2
101-3
101-4
101-5
101-6
101-7
101-8
101-10
102-1
102-10
102-2
102-4
102-5
e-STUDIO2820C/2830C/3520C/3530C/4520C
PREVENTIVE MAINTENANCE (PM)
5