Toshiba e-STUDIO2820C Service Handbook page 209

<Adjustment procedure>
(1) Take out the fuser unit from the equipment and disassemble it so that the adjustment can be per-
formed.
See the Service Handbook for the disassembly procedure.
(2) Insert the jig end (with a hole) into the first window on the separation plate viewed from the front.
Adjust it with a screw so that the 0.6 mm jig can be inserted between the separation plate and the
fuser belt, but the 1.0 mm jig cannot.
(3) Insert the jig into the last window on the separation plate viewed from the front, and then adjust it
in the same manner.
(4) Insert the jig into the remaining three windows on the separation plate, and then adjust them in
the same manner.
* If the 0.6 mm jig cannot be inserted, the gap is too narrow. Adjust it again.
* If the 1.0 mm jig can be inserted, the gap is too wide. Adjust it again.
Separation plate gap jig
Separation plate
Notes:
• When thin paper or paper with a small leading edge margin is used, the gap needs to be nar-
rower. In this case, use the jig end (without a hole). (The procedure is the same.)
- Using the jig end (with a hole): The gap is between 0.6 mm and 1.0 mm.
- Using the jig end (without a hole): The gap is between 0.6 mm and 0.8 mm.
• Paper jams tend to occur in equipment in which thin paper such as 64g/m
is used or a large amount of high density images such as pictures are output. For this equip-
ment, we recommend that you adjust the gap of the separation plate within the range of 0.6
mm to 0.8 mm in order to prevent paper jamming.
© 2008 TOSHIBA TEC CORPORATION All rights reserved
0.6 mm
0.8 mm
Fig. 3-39
e-STUDIO2820C/2830C/3520C/3530C/4520C
3 - 77
Hole
1.0 mm
0.6 mm
2
(17lb. Bond) paper
ADJUSTMENT
3