Sata Dom Support - QUANTA W Mainboard Series S210-MBT2W Technical Manual

A S
BOUT THE ERVER
SAS connectors cannot be used on S210-MBT2W. Since
Quad miniSAS connectors can support 4 SAS/SATA ports, this
allows removal of 4 individual 7pin connectors, which take up
more area. T22W needs to support 10 SATA/SAS ports. 8 of
these ports need to go to HSBPs and 2 are reserved for ODDs
(Optical Device Drives) as well as a few other SATA device
options (See Table below).
[1.3.91] S210-MBT2W SATA/SAS Port Mapping Table 21:
PORT TYPE
PBG RHS
SATA 6G
SCU0/SCU1:
SAS 6G
PORT[7:0]
PBG LHS
AHCI: SATA 6G
PORT[1:0]

[1.3.92] SATA DOM Support

[1.3.93] The S210-MBT2W does not have the necessary
design hooks in place to support a SATA DOM (Disk on Mod-
ule) with a special pin on the 7-pin connector dedicated for
power (see NOTE below). However, it can support a SATA
DOM where power is provided through an external 4 pin HDD
power cable connected to the power supply. It can also support
a cabled SATA SSD in a DIMM form-factor; provided an empty
DIMM slot is available.
CONNECTOR DEVICE
8 x 7-pin HSBP
Opt1: ODD
2 x 7-pin Opt2: SSD
direct connect
Note:
[1.3.94] There is a Common Core CCB proposing additional
circuits to be added to existing 7pin SATA connectors for sup-
porting the Pin7 Power option SATA DOM. Whether or not
this can be supported on certain Romley Products will be
decided by each PDT.
Note:
[1.3.95] S210-MBT2W also support On board Power on
SATA DOM as Alternative.
1-40
S A SCSI / S ATA
ERIAL TTACHED ERIAL