Troubleshooting - QUANTA W Mainboard Series S210-MBT2W Technical Manual

T
ROUBLESHOOTING

[5.1.1] Troubleshooting

[5.1.2] System does not Boot after initial installation:
Power Cord Not Plugged In

Processor Issues

Memory Issues

Monitor Issues

Power Supply, Chassis and Fan Issues

Cable Issues

Electrical Short or Overload

Defective Components

[5.1.3] System does not boot after configuration changes:
Hardware Changes

Software Changes

BIOS Changes

Installation Problems

Troubleshooting External Connections

[5.1.4] System does not Boot after
Initial Installation
[5.1.5] Power Cord Not Plugged In
[5.1.6] If the power supply cable is not plugged into the chassis
power connector, the system cannot boot up, even though
chassis front panel LEDs and the fan may be operational. Verify
that the power connections are good.
[5.1.7] Processor Issues
[5.1.8] Boot failure situations are also caused by the following:
[5.1.9] Incompatible processor - ensure the selected processor
model is correct for your server board. If the processor is com-
patible, try removing and reinstalling the processor to ensure it
is installed correctly.
[5.1.10] Processor overheat-the system does not boot or shuts
down shortly after booting.
Ensure that the cooling fans are correctly installed and

running.
Ensure that the correct thermal interface material or the

thermal grease is applied to the processor.
5-1
T
ROUBLESHOOTING