QUANTA W Mainboard Series S210-MBT2W Technical Manual page 200

BMC
[3.1.101] This Active Directory Settings page in MegaRAC SP-
X as shown on the following figure, allows to Configure Active
Directory Server Settings.
[3.1.102] To open Active Directory Settings page, click Config-
uration > Active Directory from the main menu. A sample
screenshot of Active Directory Settings Page is shown in the
following screenshot:
[3.1.103] Active Directory Settings Page
[3.1.104] Active Directory Settings Page
I
TEM
Active Directory advanced settings configuration
options are as follows:
Enable Active Directory Authentication,

Advanced Settings User Domain name,

Time Out, and

Up to three Domain Controller Server

Addresses.
D
ESCRIPTION
3-13
[3.1.104] Active Directory Settings Page (Continued)
I
TEM
The name that identifies the role group in the
Active Directory.
Role Group Name is a string of 255 alpha-

Role Group ID
numeric characters.
Special symbols hyphen and underscore are

allowed.
This name identifies the role group in Active
Directory.
Note:
Group Name
Role Group Name is a string of 255 alpha-

numeric characters.
Special symbols hyphen and underscore are

allowed.
The domain where the role group is located.
Note:
Domain Name is a string of 255 alpha-
Group Domain 
numeric characters.
Special symbols hyphen, underscore and dot

are allowed.
Group Privilege The level of privilege to assign to this role group.
Add Role Group To add a new role group to the device.
To modify that role group. Alternatively, double
Modify role Group
click on the configured slot.
Delete Role Group To delete an existing Role Group.
C G
ONFIGURATION ROUP
D
ESCRIPTION