Usb; Bios Usb Debug Support; Wake-On-Usb - QUANTA W Mainboard Series S210-MBT2W Technical Manual

A S
BOUT THE ERVER

[1.3.52] USB

[1.3.53] There are 14 USB 2.0 ports available from Patsburg.
All ports are high-speed, full-speed and low-speed capable. A
total of 10 USB 2.0 dedicated ports are required in order to sup-
port the S210-MBT2W Enterprise Server and Extreme Server
SKU products.
[1.3.54] USB 2.0 port distribution is as follows; ASPEED
AST2300 BMC and the Zepher module consume 3 USB 2.0
ports, an internal 1x4 Type-A USB connector consumes 1 USB
2.0 port and 6 external USB 2.0 ports are needed (2 at front and
4 at rear).
Note:
[1.3.55] USB ports on the Romley-EP S210-MBT2W
board are required to be powered from STBY.
Note:
[1.3.56] USB Port 0 must be assigned to one of the rear I/
O panel ports for Microsoft Kernel Debug.
Note:
[1.3.57] There are 14 USB 2.0 per the Patsburg SSB C-
spec 1.0 document.
[1.3.58] There are 14 USB 2.0 per the Patsburg SSB C-spec
1.0 document.
[1.3.59] BIOS USB Debug Sup-
port
[1.3.60] USB 2.0 UHCI Port#1 or Port#9 (assuming 0-based
numbering) MUST be connected to one of the external USB
connectors for BIOS Debug and Microsoft Kernel Debug. Refer
to Romley WW52 2009 MOW for details.

[1.3.61] Wake-on-USB

[1.3.62] S210-MBT2W Server shall support Wake on USB on
the rear and front panel USB ports for S1. S210-MBT2W will
also support Wake on USB from S3/S4/S5. As a result,
Standby power on USB ports is required.
1-34
USB