QUANTA W Mainboard Series S210-MBT2W Technical Manual page 213

BMC
3.1.227.4.In the Filter Action configuration section,
Event Filter Action is a mandatory field and checked by

default, which enable PEF Alert action (read-only).
Select any one of the Power action either Power down,

Power reset or Power cycle from the drop down list
Choose any one of the configured alert policy number

from the drop down list.
Note:
[3.1.228] Alert Policy has to be configured - under
ration > PEF > Alert Policy
3.1.229.5.In the Generator ID configuration section,
Check Generator ID Data option to fill the Generator ID

with raw data.
Generator ID 1 field is used to give raw generator ID1

data value.
Generator ID 2 field is used to give raw generator ID2

data value.
Note:
[3.1.230] In RAW data field, to specify hexadecimal value prefix
with '0x'.
In the Event Generator section, choose the event gen-

erator as Slave Address - if event was generated from
IPMB.Otherwise as System Software ID - if event was
generated from system software.
Configu-
.
3-26
In the Slave Address/Software ID field, specify corre-

sponding I2C Slave Address or System Software ID.
Choose the particular channel number that event mes-

sage was received over. Or choose '0' if the event mes-
sage was received via the system interface, primary
IPMB, or internally generated by the BMC.
Choose the corresponding IPMB device LUN if event

generated by IPMB.
3.1.231.6.In the Sensor configuration section,
Select the s type of sensor that will trigger the event fil-

ter action.
In the sensor name field, choose the particular sensor

from the sensor list.
Choose event option to be either All Events or Sensor

Specific Events.
3.1.232.7.In the Event Data configuration section,
Event Trigger field is used to give Event/Reading type

value.
Note:
[3.1.233] Value ranges from 1 to 255.
Event Data 1 AND Mask field is used to indicate wild-

carded or compared bits.
C G
ONFIGURATION ROUP