QUANTA W Mainboard Series S210-MBT2W Technical Manual page 214

BMC
Note:
[3.1.234] Value ranges from 0 to 255.
Event Data 1 Compare 1 & Event Data 1 Compare 2

field is used to indicate whether each bit position's com-
parison is an exact comparison or not.
Note:
[3.1.235] Value ranges from 0 to 255.
3.1.236.8.In the Event Data 2 configuration section,
Event Data 2 AND Mask field is similar to Event Data 1

AND Mask.
Event Data 2 Compare 1 & Event Data 2 Compare 2

fields are similar to Event Data 1 Compare 1 and Event
Data 1 Compare 2 respectively.
3.1.237.9.In the Event Data 3 configuration section,
Event Data 3 AND Mask field is similar to Event Data 1

AND Mask.
Event Data 3 Compare 1 & Event Data 3 Compare 2

fields are similar to Event Data 1 Compare 1 and Event
Data 1 Compare 2 respectively.
3.1.238.10.Click Modify to accept the modification and
return to Event filter list.
3.1.239.11.Click Reset to reset the modification done.
3.1.240.12.Click on Cancel to cancel the modification and
return to Event filter list.
3.1.241.13.In the Event filter list, click Modify to modify the
existing filter.
3.1.242.14.In the Event filter list, click Delete to delete the
existing filter.
[3.1.243] Alert Policy Tab
[3.1.244] This page is used to configure the Alert Policy and
LAN destination. You can add, delete or modify an entry in this
page.
[3.1.245] PEF Management – Alert Policy
[3.1.246] The fields of the PEF Management – Alert Policy Tab
are explained below.
3-27
C G
ONFIGURATION ROUP