Installation Problems - QUANTA W Mainboard Series S210-MBT2W Technical Manual

T
ROUBLESHOOTING
[5.1.34] If you cannot access the BIOS Setup Utility, clear the
CMOS by performing the following steps:
5.1.35.1.Power down the server. Do not unplug the power
cord.
5.1.36.2.Open the server chassis
5.1.37.3.Move the CMOS CLEAR jumper from the default
operation position, covering pins 1 and 2, to the reset /
clear CMOS, covering pins 2 and 3.
5.1.38.4.Remove AC power.
5.1.39.5.Wait 5 seconds.
5.1.40.6.Move the jumper back to default position, covering
pins 1 and 2.
5.1.41.7.Close the server chassis and power up the server.
[5.1.42] The CMOS is now cleared and can be reset by going
into BIOS setup.
[5.1.43] Please refer to http://www.QuantaQCT.com
BIOS update.

[5.1.44] Installation Problems

[5.1.45] Perform the following checks if you are troubleshooting
an installation problem:
[5.1.46] Check all cable and power connections (including all
rack cable connections). Unplug the power cord, and wait one
minute. Then reconnect the power cord and try again. If the net-
work is reporting an error, see if the server has enough memory
and disk space available. Remove all added options, one at a
time, and try to power up the system. If after removing an option
the server works, you may find that it is a problem with the
option or a configuration problem between the option and the
server. Contact the option vendor for assistance.
If the system doesn't power on, check the LED display. If

the power LED is not on, you may not be receiving AC
power. Check the AC power cord to make sure that it is
securely connected.
for the
[5.1.47] Troubleshooting External Con-
nections
[5.1.48] Loose or improperly connected cables are the most
likely source of problems for the system, monitor, and other
peripherals (such as a keyboard, mouse, or other external
device). Ensure that all external cables are securely attached to
the external connectors on your system.
[5.1.49]
5-4
T
ROUBLESHOOTING