QUANTA W Mainboard Series S210-MBT2W Technical Manual page 201

BMC
[3.1.105] Procedure:
[3.1.106] Entering the details in Advanced Active Directory Set-
tings Page
3.1.107.1.Click on Advanced Settings to open the
Advanced Active Directory Settings Page.
[3.1.108] Advanced Active Directory Settings Page
F
3.1.109.2.In the Active Directory Settings Page, enter the fol-
lowing details.
3.1.110.3.Active Directory Authentication: To enable/dis-
able Active Directory, check or uncheck the Enable
checkbox respectively.
Note:
[3.1.111] If you have enabled Active Directory Authentication,
enter the required information to access the Active Directory
server.
3.1.112.4.Specify the Domain Name for the user in the User
Domain Name field. e.g. MyDomain.com
3.1.113.5.Specify the time (in seconds) to wait for Active
Directory queries to complete in the Time Out field.
Note:
Default Time out value: 120 seconds.

Range from 15 to 300 allowed.

3.1.114.6.Configure IP addresses in Domain Controller
Server Address1, Domain Controller Server Address2
& Domain Controller Server Address3.
Note:
[3.1.115] IP address of Active Directory server: At least one
Domain Controller Server Address must be configured.
IP Address made of 4 numbers separated by dots as in

"xxx.xxx.xxx.xxx".
Each number ranges from 0 to 255.

First number must not be 0.

Note:
[3.1.116] Domain Controller Server Addresses will supports
IPv4 Address format and IPv6 Address format.
3.1.117.7.Click Save to save the entered settings and return
to Active Directory Settings Page.
3.1.118.8.Click Cancel to cancel the entry and return to
Active Directory Settings Page.
[3.1.119] To add a Role Group
3-14
C G
ONFIGURATION ROUP