Electromagnetic Compatibility Notices - QUANTA W Mainboard Series S210-MBT2W Technical Manual

R C I
EGULATORY AND OMPLIANCE NFORMATION

[8.2.27] Electromagnetic Compatibility Notices

[8.2.28] FCC Verification State-
ment (USA)
[8.2.29] This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
[8.2.30] This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the

receiver
Connect the equipment to an outlet on a circuit other than

the one to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician

for help.
[8.2.31] Any changes or modifications not expressly approved
by the grantee of this device could void the user's authority to
operate the equipment. The customer is responsible for ensur-
ing compliance of the modified product.
[8.2.32] Only peripherals (computer input/output devices, termi-
nals, printers, etc.) that comply with FCC Class A or B limits
may be attached to this computer product. Operation with non-
compliant peripherals is likely to result in interference to radio
and TV reception.
[8.2.33] All cables used to connect to peripherals must be
shielded and grounded. Operation with cables, connected to
peripherals, that are not shielded and grounded may result in
interference to radio and TV reception.
8-2
E C N
LECTROMAGNETIC OMPATIBILITY OTICES