Updating The Firmware - Panasonic DP-3510 Service Manual

3.6.

Updating the Firmware

The Quickest and Most Reliable Way of Updating the Firmware is to use the Network Firmware
Program Tool (FUP) using Ethernet LAN Port and a Crossover Cable.
The network FUP Tool version must be 3.XX or higher, and it can be found on the CD included with PCL or
PS/PCL options.
Refer to the Firmware Update Operation Instructions and Service Notes for Option Instalation
(8.1, 8.2.) for the details.
3.6.1. Firmware Configuration
A. Hardware Configuration
This machine is controlled by three (3) CPUs which are located on the System Control (SC) PC
Board, the Panel Control (PNL) PC Board and the Scanner Printer Control (SPC) PC Board.
PC
Ethernet Port
PC
Parallel Port
Flash Memory
Card
4 MB or 8 MB
B. SC PC Board Firmware
The standard onboard Program Memory (F-ROM) mounted on the SC PCB is 4 MB. Two (2) Optional
Expansion 8 MB Program Memory (FRM8 PCB) can be installed into SLOT 1 and SLOT 2.
The Firmware to be written into the 4 MB onboard, the 8 MB of SLOT 1 / SLOT 2 depend upon the
configuration of the Standard, PCL or PS Options.
(1) Standard
The Standard Program is only written into the 4 MB onboard, which is assigned as ROM Code (A).
(2) For PCL Option
The PCL Control Program must be written into the 4 MB onboard, which is assigned as ROM Code
Ver. 5.2
SC PC Board
On Board
F-ROM
CPU
Slot 1
FRM8 PCB
Slot 2
FRM8 PCB
PNL PC Board
F-ROM
CPU
SPC PC Board
F-ROM
CPU
512 KB
131
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
Standard
Configuration
(A)
(1)
Program
4 MB
4 MB
8 MB
8 MB
Panel Control Program (Display & Key In)
Bitmap Data
4 MB
Font Data
Scanner Control Program
Printer Control Program
With PCL Option With PS Option
Configuration Configuration
(B) (D)
(2) (5)
Program Program
4 MB
4 MB
(C) 8MB (E) 8MB
(3) (6)
Program Program
(a)
4 MB 4 MB
(4) (7)
Font Program
(b)
4 MB
4 MB
JAN 2006
(a)
(b)