Panasonic DP-3510 Service Manual page 820

5. E7-58, Punch Sensor (Waste Full) Fault
Waste Full Sensor (Waste Full Photo Sensor PCB / Waste Full LED PCB)
1) Check the waste full sensor. Is the sensor normal?
NO : Replace the sensor.
Wiring
2) Is the wiring between the punch controller PCB and the waste full sensor normal?
NO : Correct the wring.
Punch Controller PCB, Finisher Controller PCB
3) Try replacing the punch controller PCB. Is the problem corrected?
YES: End.
NO : Replace the Finisher Controller PCB.
6. E7-29, Horizontal Registration Motor Fault
Horizontal Registration Home Position Sensor (PI2P)
1) Check the horizontal registration home position sensor. Is the sensor normal?
NO : Replace the sensor.
Wiring
2) Is the wiring between the Finisher Controller PCB and the horizontal registration
home position sensor normal?
NO : Correct the wring.
Horizontal Registration Mechanism, Horizontal Registration Motor (M2P)
3) Is there a fault in the horizontal registration mechanism?
YES: Correct the horizontal registration mechanism.
NO : Replace the horizontal registration motor.
Punch Controller PCB, Finisher Controller PCB
4) Try replacing the punch controller PCB. Is the problem corrected?
YES: End.
NO : Replace the Finisher Controller PCB.
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
Table 5-030
Table 5-031
820
JAN 2006