Panasonic DP-3510 Service Manual page 362

Tag
Ver. 5.2
Tray
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
(3) Remove the Pads from the Top Cover.
(4) Lift the Front Caster slightly, and remove the
Pad. Repeat the same procedure and lift the
Rear Caster slightly and remove the Pad.
Caution:
The Finisher is equipped with Casters, and tends
to roll easily. Be sure to work in a group of two, and
exercise caution not to drop the finisher or getting
hurt. Moreover, be sure to pay attention when
shifting the Finisher to avoid deforming the Rail
Base.
(5) Open the Covers and remove all tapes and
packing materials.
(6) Close the Covers.
Caution:
The removed Tapes and Packaging Material will
be required when transporting the Machine for
relocation or repairs; it is a good idea to store them
for future use.
3. Preparing for the Installation of the Finisher
Assembly
Caution:
Before connecting the Finisher to its Host
Machine, mount the Trays and other parts to the
Finisher first.
(1) Install 2 Trays to the Finisher. Starting with the
bottom Tray, and then install the upper Tray next.
(2) As shown, fit the bosses on the Tray into the
holes in the Horizontal Frames, and lower it. Be
sure that the bosses on both sides of the Tray
slide into the holes in the Vertical Tray, leaving
no gap.
362
JAN 2006