Updating The Firmware; Firmware Configuration; Hardware Configuration; Sc Pc Board Firmware - Panasonic DP-3030 Service Manual

3.7.

Updating the Firmware

The Quickest and Most Easiest Method of Updating the Firmware is to use the Network Firmware
Tool (FUP) using Ethernet LAN Port and a Crossover Cable.
The Network FUP Tool version must be 3.XX or higher, and it can be found on the Panasonic Document
Management System CD-ROM included with the main unit or on the CD-ROM included with the PCL or
PS/PCL options.
Refer to the Firmware Update Operation Instructions, Service Notes (8.1. or 8.2) for additional
details.
3.7.1.

Firmware Configuration

A. Hardware Configuration
This machine is controlled by three (3) CPUs which are located on the System Control (SC) PC
Board, the Scanner Printer Control (SPC) PC Board and the Panel Control (PNL) PC Board.
PC
Ethernet Port
PC
USB Port
Flash Memory
Card
4 MB or 8 MB
B. SC PC Board Firmware
The 4 MB Program Memory (F-ROM) is integrated on the SC PCB. Two (2) Optional Expansion 8 MB
Program Memory (FRM8 PCB) can be installed into SLOT 1 and SLOT 2.
The Firmware to be written into the 4 MB onboard, the 8 MB of SLOT 1 / SLOT 2 depends upon the
configuration of the Standard, PCL or PS Options.
(1) Standard
The Standard Program (1) is only written into the 4 MB onboard, which is assigned as ROM
Code (A).
Ver. 2.1
SC PC Board
On Board
F-ROM
CPU
Slot 1
FRM8 PCB
Slot 2
FRM8 PCB
SPC PC Board
F-ROM
CPU
512 KB
PNL PC Board
F-ROM
CPU
97
Standard
Confi g uration
(A)
(1)
Program
4 MB
4 MB
8 MB
8 MB
Scanner Control Program
Printer Control Program
Panel Control Program (Display & Key In)
Bitmap Data
Font Data
4 MB
DP-2310/3010
DP-2330/3030
With PCL Option With PS Option
Confi g uration Confi g uration
(B) (D)
(2) (5)
Program Program
4 MB
4 MB
(C) 8MB (E) 8MB
(3) (6)
Program
Program
2 MB
(a)
4 MB
(4) (7)
Font
Font
(b)
4 MB
4 MB
MAR 2005
(a)
(b)