Panasonic DP-3510 Service Manual page 334

(12)
(11)
(14)
UL Tape (Black)
(18)
Ver. 5.2
(13)
Key
(12)
(11)
(15)
(16)
(17) (17)
(20)
(19)
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
(11) Install the HDD into the HDD Bracket.
(12) Secure the HDD Bracket with 4 Silver Screws
(Short).
(13) Connect one end of the HDD2 Harness and HD
Harness to the HDD.
(14) Install the HDD Assembly.
(15) Secure the HDD Assembly with 2 Screws
(Long).
Note:
Route the HDD2 Harness (Power Supply Cable)
through the cutout in the frame and secure it with
the Harness Clamp as illustrated.
(16) Connect the HD Harness to CN59 on the SC PC
Board as illustrated.
(17) Remove the Screw from the frame, and secure
the HD Harness Clamp with this Screw as
illustrated.
Note:
Ensure that the clamp is around the shielded
portion of the Harness, and not around the UL
Tape (Black).
(18) Install the DC PCB Assembly.
Note:
If the Fax Communication Board (DA-FG600) is
installed, disconnect the CN392 Harness on the
FX PCB. Route the Harness over the DC PCB
Bracket and secure it with the Clamp. Reconnect
the Harness to CN392 on the FX PCB.
(19) Secure the DC PCB Assembly with 3 Screws
(Long).
(20) Connect the HDD2 Harness (Power Supply
Cable) to CN143 on the DCB PC Board.
334
JAN 2006