Panasonic DP-3510 Service Manual page 132

(B). The PCL Control Program (3) and PCL Font data (4) are written into the 8 MB in the SLOT 1.
The Firmware (3) and (4) are assigned as ROM Code (C).
When using 8 MB Flash Memory Card, the 8 MB Program (C) can be written at once.
Using 4 MB Flash Memory Card, the 8 MB program (C) must be divided by 2 Programs for Program
4 MB (3) and Font 4 MB (4).
(3) For PS Option
The PS Control Program must be written into the 4 MB onboard, which is assigned as ROM Code
(D). The PS Control Program (6) and (7) are written into the 8 MB in the SLOT 1.
Both Firmwares (6) and (7) are assigned as ROM Code (E).
When using 4 MB Flash Memory Card, the 8 MB program (E) must be divided onto 2 cards, one 4
MB card for the PS Control Program (6) and one 4 MB card for the PS Control Program (7).
C. Panel (PNL) PC Board Firmware
The 4 MB Program Memory (F-ROM) is mounted on the PNL PCB as a standard. The Programs for
Key Scan, Display Control, Energy Save Control, Bitmap Data and Font Data are saved in this Board.
The Firmware is transferred as Serial Data from SC PCB.
D. SPC PC Board Firmware
The 512 KB Program Memory (F-ROM) is mounted on the SPC PCB as a standard. The Programs for
Scanner Control and Printer Control are saved in the Board. The Firmware is transferred as Serial
Data from SC PCB.
E. Firmware Updating Ports
Three (3) types of Ports are available for updating the firmware.
(1) Ethernet LAN Port (The Quickest and Most Reliable Way)
The machine's Firmware can be updated from a PC via Local Area Network (LAN). Refer to the
Firmware Update Operation Instructions, Caution (8.1.) and Service Notes (8.2.) for the details.
(2) Parallel Port (Back up)
The machine's Firmware can be updated from a PC via Parallel Port. The Master Firmware Card
can also be created from a PC via Parallel Port. Refer to the Firmware Update Operation
Instructions, Caution (8.1.) and Service Notes (8.2.) for the details.
(3) Flash Memory Card
The machine's Firmware can be updated using the Master Firmware Card. The Master Firmware
Card can be created by copying the Firmware from an existing machine's SC PCB using a 4 MB or
8 MB Flash Memory Card.
It is required 5 Flash Memory Cards to update the SC, PNL and SPC PCBs.
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
132
JAN 2006