Panasonic DP-3510 Service Manual page 227

5.1.5. F6 Mode: Adjust Parameters (For Copier)
Set the machine to Service Mode and press "6" key on the Keypad.
↓
Press the "START" key.
↓
Select the desired code number on the Touch Panel display.
↓
If you wish to select another code number, scroll the menu with the arrow buttons.
↓
Select the desired function on the Touch Panel display and touch the "OK" button.
↓
When the "C (CLEAR)" key is touched, the selected code input will not be accepted.
↓
Press "FUNCTION" and "C (CLEAR)" keys simultaneously to exit the service mode.
↓
Reboot the machine after setting the parameter(s) to activate the setting(s).
Note:
The Factory Setting is different in each model.
No.
00 Adjust 100% read (s/s)
01 Adjust read mag. (l/t)
02 100% selection
03 Original registration
04 Printer registration
05 Main motor speed
06 Polygon motor speed
07 Registration void
08 Trail edge read timing
09 Trail edge print timing
10 Side adjust (Bypass)
11 Side adjust (Tray 1)
12 Side adjust (Tray 2)
13 Side adjust (Tray 3)
Ver. 5.2
Item
Adjustment of ratio for vertical position when
scan is made.
Adjustment of ratio for parallel position when
scan is made.
Adjustment from 99.1% to 100.9%
Adjustment of platen original registration
detection timing.
Delay time is adjusted from registration roller
clutch ON.
Adjustment of Main Motor speed.
Adjustment Polygon Motor speed.
Registration void should be adjusted.
Adjustment of trail edge void.
Adjustment of trail edge void.
Adjustment of LSU side-side (Sheet Bypass).
Adjustment of LSU side-side (1st Tray).
Adjustment of LSU side-side (2nd Tray).
Adjustment of LSU side-side (3rd Tray).
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
F6 Mode
Remarks
227
Setting
Range
-9 - +9 0.1%
-9 - +9 0.1%
-9 - +9 0.1%
-30 - +30
0.2mm
-50 - +50
0.5mm
-10 - +10
0.1%
-99 - +99
0.1%
0 - +99
0.5mm
-9 - 0
0.5mm
-9 - +15
0.5mm
-8 - +7
0.5mm
-8 - +7
0.5mm
-8 - +7
0.5mm
-8 - +7
0.5mm
JAN 2006