Panasonic DP-3510 Service Manual page 803

11.3.5.1.2. Electrical System (Punch Unit; Option)
1. Adjusting the Sensor Output
Perform the following when the Punch Controller PCB, Horizontal Registration Sensor (Photosensor
PCB/LED PCB), or Waste Full Sensor (Waste Full Photosensor PCB / Waste Full LED PCB) has been
replaced.
1) Shift bits 1 through 4 on the Punch Controller PCB as follows :
2) Press SW1002 or SW1003 on the Punch Controller PCB. A press will automatically adjust the
sensor output.
• The adjustment is over when all LEDs on the Punch Controller PCB are ON: LED1001, LED1002,
LED1003.
3) Shift all bits of DIPSW1001 to OFF.
2. Registering the Number of Punch Hole
Perform the following to register the type of punch unit (number of holes) used to the IC on the Punch
Controller PCB for identification by the Finisher. Be sure to register the type whenever you have
replaced the Punch Controller PCB.
1) Set bits 1 through 4 on the DIPSW1001 on the Punch Controller PCB as follows :
2) Press SW1002 on the Punch Controller PCB to select the appropriate number of punch holes.
• Each press on SW1002 moves the selection through the following (repeatedly from top to bottom).
Number of Punch Hole
2 holes (Punch Unit DA-SP41-AZ)
2 / 3 holes (Punch Unit DA-SP41-PU)
4 holes (Punch Unit DA-SP41-PB)
3) Press SW1003 on the Punch Controller PCB twice. The presses will store the selected number of
punch holes on the Punch Controller PCB.
• A single press on SW1003 will cause the LED indication to flash; another press on SW1003 will
cause the indication to remain ON to indicate the end of registration.
4) Shift all bits of DIPSW1001 to OFF.
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
ON
1 2 3 4
Fig. 5-005
ON
1 2 3 4
Fig. 5-006
LED1001
ON
ON
OFF
Table 5-001
803
LED1002 LED1003
OFF OFF
ON OFF
ON OFF
JAN 2006