Panasonic DP-3510 Service Manual page 368

<Punch Unit is NOT installed>
(4)
<Punch Unit is installed>
(4)
Wrench
Ver. 5.2
Alignment
Lines
A
B
Alignment
Lines
A
B
Screw
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
6. Adjusting the Height / Slope
Caution:
The floor of the site can at times cause a
difference in height between the Finisher and the
Host Machine or cause the Finisher to tilt,
requiring adjustment. If this is the case, adjust the
difference/slope as follows; if installation of a
Punch Unit is planned, see its Installation
Procedure.
(1) Check the height and the slope of the Finisher
and its Host Machine; if adjustment is needed,
be sure to correct the height before adjusting the
slope.
(2) If there is a difference in Height between the
upper surface of the Right Guide Assembly of
the Finisher and the Alignment Lines on the Left
Platen Cover of the Host Machine: Align the
upper surface of the Right Guide Assembly of
the Finisher to the Alignment Lines on the Left
Platen Cover of the Host Machine.
(3) Adjust the Finisher level with 4 Adjusters.
Note:
Make sure the Gaps "A" and "B" are the same.
(4) Attach the Label as illustrated.
(5) Open the Finisher Front Cover, and remove the
Screw used to hold the Wrench in place from
behind the Front Cover; then, detach the
Wrench.
368
JAN 2006