Important Notice - Panasonic DP-3510 Service Manual

Important Notice

Please read this notice completely BEFORE installing any
optional accessories. As failure to properly install the additional
board or connector with the power ON (only the front power
switch Off) could damage the copier's SPC or SC board.
Please follow the instructions below:
1. It is essential that you turn OFF power to the Main Power
Switch located in the rear of the copier.
2. It is essential that you unplug the Main AC Power Cord from
the wall outlet.
3. Please carefully read the installation instructions and follow
each step.
Note 1:
The Main Power Switch location may differ slightly depending on the model.
Note 2:
O = Power OFF, l = Power ON
Note:
If the Hard Disk Drive Unit is installed, to prevent a Disk Scan Function from being
performed (similar to when the power is abruptly interrupted to the PC), it is
important to follow the step sequence below when turning OFF the Power Switches on
the machine.
1. Turn the Power Switch on the Left Side of the machine to the OFF position first.
2. Wait approximately 10 seconds while the machine writes the closing status onto the Hard Disk
Drive Unit.
3. Turn the Main Power Switch on the Back of the machine to the OFF position.
(This interrupts all the power to the machine, but does not disconnect the main line.)
4. Unplug the AC Power Cord to shut the power Off completely.
* The specifications are subject to change without notice. Panasonic Communications Co., Ltd. reserves
the right to make improvements in the product design without reservation and without notice.
3