5.1.20 Drive Cage
To remove the drive cage from the computer chassis, complete the following steps:
1. Perform the preparation procedures described in Section 5.1.3.
2. Remove the system unit cover (Section 5.1.6).
3. Remove the front bezel (Section 5.1.15.1).
4. Remove the two screws that secure the drive cage to the chassis.
5. Slide the drive cage towards the inside of the chassis to release the latches.
6. Lift the assembly up.
Figure 5-52. Removing the Drive Cage
To install the drive cage, reverse the above procedure.
5-56
Removal and Replacement Procedures