Compaq DESKPRO 2000 SERIES Maintenance & Service Manual page 163

1. Install one wafer screw on each side of the front of the drive.
Figure 5-44. Installing the Wafer Screws into the Drive
2. Install the drive assembly into the drive bay. If this is a 3.5-inch drive, the retaining screw is installed
on the left side of the drive bay. If this is a 5.25-inch drive, the retaining screw is installed on the
right side of the drive bay.
Figure 5-45. Installing the Drive
3. Continue with step 8.
4. If you are installing a 3.5-inch diskette drive, use bracket number 243230-001 which comes with a
preinstalled bezel. This bracket is available from your Compaq dealer or service provider.
If you are installing a 3.5-inch hard drive, use bracket number 243231-001. This bracket is available
from your Compaq dealer or service provider.
5-50 Removal and Replacement Procedures