Compaq DESKPRO 2000 SERIES Maintenance & Service Manual page 66

Error Code
XXXX-02
XXXX-03
XXXX-05
XXXX-06
XXXX-07
XXXX-08
XXXX-09
XXXX-10
XXXX-11
XXXX-12
XXXX-13
XXXX-14
XXXX-15
XXXX-16
XXXX-17
XXXX-18
XXXX-21
65XX-24
66XX-24
67XX-24
XXXX-25
XXXX-30
XXXX-31
XXXX-32
XXXX-33
XXXX-34
XXXX-35
XXXX-36
XXXX-39
XXXX-40
2-24 Troubleshooting
SCSI Test Error Codes
Description
Drive not installed.
Media not in drive.
Seek failure.
Drive timed out.
Drive busy.
Drive already reserved.
Unknown.
Unknown.
Media soft error.
Drive not ready.
Media error.
Drive hardware error.
Illegal drive command.
Media was changed.
Tape write-protected.
No data detected.
Drive command aborted.
Media hard error.
Media hard error.
Media hard error.
Unknown.
Controller timed out.
Unrecoverable error.
Controller/drive disconnected.
Illegal controller command.
Invalid SCSI bus phase.
Invalid SCSI bus phase.
Invalid SCSI bus phase.
Error status from drive.
Target timed out.
Table 2-18
Recommended Action
Check cable connections.
Check for and install DATA CD or write-enabled
tape in drive.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
1. Disable write-protect on tape cartridge.
2. Replace tape drive.
Replace the indicated device.
Replace the indicated device.
1. Back up data and perform Surface Analysis
to reallocate defect.
2. Replace drive.
1. Replace current DATA CD with different
DATA CD.
2. Replace drive.
1. Ensure correct media type for this tape drive.
2. Replace current tape with new tape.
3. Replace tape drive.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Replace the indicated device.
Continued