5.1.10.3 Cache Memory
To install an optional cache module onto a Pentium-based system board, complete the following steps:
1. Perform preparation procedures described in Section 5.1.3.
2. Remove the system unit cover (Section 5.1.6).
3. Remove the front bezel (Section 5.1.15.1).
4. Remove the drive cage (Section 5.1.20).
5. Locate the cache connector on the system board.
Figure 5-22. Locating the Cache Connector on the System Board
6. Install the cache module into the cache connector on the system board.
7. Replace the system unit cover.
8. Reconnect all the cables and turn on the computer. The computer reconfigures the additional
memory. Refer to Chapter 7, "Compaq Utilities."
5-26
Removal and Replacement Procedures